New rear fenders in Carbon Fiber

[mark cummins]

After six months of Nights and weekends of Bondo and fiberglass Hackage the plug is done and the molds finished ..the result is on the smart...couple of changes to be made on the molds..but its close..and Now carbon fiber is getting VERY hard to purchase
I have at least one set ...So I can run the 17x9s..Only If One could get tires in the states for this set up..

http://x402.putfile.com/4/10312522327.jpg

http://x402.putfile.com/4/10312503591.jpg

http://x402.putfile.com/4/10312532482.jpg

[Mike T]

Not that I'm interested in buying, but what would the cost of a set of these be? And do you have plans to make matching front fenders, nose cone, doors and tailgate

[mark cummins]

Molds were 3,000.00 plus over 100 hours of building the prototype fenders .Just made them to fit my Smart so the 17 x 9 Titans would clear the Fenders
So Yes I have a set of VERY Expensive rear fenders

No Plans to build any other fenders/panels for the smart..I did this because No One out there has made a rear fender that will work..and this fender fits a LOT better that the Brabus wide star..without any drilling..all bolt on using all OE smart mounting points/hardware...